My policy is if I buy reloads at a gun show, they don't go in my gun until I disassemble them and reload them to my specs. I picked up some 43 Mauser...
From the looks of it no one has done it yet. However there are printers that use metals including stainless steel. Nobody has done it yet but yes it...
Who cares about meat damage, it's not that bad at all. On whitetails why does it matter if a bullet comes apart, any 300wm cupncore driven fast will...
Disassemble them for sure, I would never trust a single reload, you not know what their control is and you are causing a controlled explosion inches...
