Printable View
The unit doesn’t measure signal strength in real time. It would have done so when the unit was programmed to upload images. Perhaps your unit finally connected to the cell tower. If so 25% signal strength is very poor considering the distance you are from the tower.Quote:
Originally Posted by Rick_ca
Hooked mine up to a Stealth cam without issue and is working great. Its set for 90 seconds. Instructions say more than a minute.
As I said I didn't give up on Spy Point after bad experience with cell link so this week i purchased a spy point link micro and setup in same location as where I tested the cell link and the unit work perfect now I just have figure out the optimum setting for my use thanks to all who offered advice
Make sure you go on the website and have tech support update the firmware on the cameras to the most updated version. Will help the camera work better. I had some recent issues with my cams and the update fixed it right up
yes just trying to do that LOL did what site say unzipped file and open update and copied the 7 files to micro sd card but its still running previous ver when I checked phone and their service tech says to copy all files once downloaded so going to try installing the 2 files that down loaded and go from thereQuote:
Originally Posted by marky.mark
3rd Attempt it took the update now to setup setting things are looking up for taking out in the bush next weekend:thumbup: might look on amazon for a solar panel for itQuote:
Originally Posted by Rick_ca
Any luck getting your Cell Link working or did you return it for the Micro Link camera?Quote:
Originally Posted by Rick_ca
i returned it and went with micro link cut out the camera aggravationQuote:
Originally Posted by Sam Menard
I’m not very cell phone savvy. Do you need to have a data plan for this to work.
No. SPYPOINT covers the cost. There are fees associated with optional plans upgrades that are paid to SPYPOINT.Quote:
Originally Posted by John B