-
April 16th, 2019, 03:03 PM
#11
Has too much time on their hands
Can this be salvaged? Heating maybe? I got it for half price... I can bring it back if not satisfied... thoughts?
IMG_0426.JPG
IMG_0430.JPG
-
April 16th, 2019 03:03 PM
# ADS
-
April 16th, 2019, 03:31 PM
#12
Can you access that spot from the inside? If so some heat and gentle persuasion will probably bring it back. Of course whenever you apply heat there is the possibility of cracking which can also be repaired fairly easily. TC
-
April 16th, 2019, 04:30 PM
#13
Has too much time on their hands
Originally Posted by
trky chsr
Can you access that spot from the inside? If so some heat and gentle persuasion will probably bring it back. Of course whenever you apply heat there is the possibility of cracking which can also be repaired fairly easily. TC
not sure I can b/c its a sit on... we'll see..
thanks
-
April 16th, 2019, 05:43 PM
#14
Originally Posted by
Splaker
Can this be salvaged? Heating maybe? I got it for half price... I can bring it back if not satisfied... thoughts?
IMG_0426.JPG
IMG_0430.JPG
Could you drill a hole on the top layer and push out bottom layer with a stick. You could plug hole afterwards. Boat plug?
"Only dead fish go with the flow."
Proud Member: CCFR, CSSA, OFAH, NFA.
-
April 16th, 2019, 06:08 PM
#15
Originally Posted by
Splaker
not sure I can b/c its a sit on... we'll see..
thanks
Sometimes there is a hatch that lets you access parts of the hull.
-
April 16th, 2019, 06:19 PM
#16
Take it back....that is a real problem since the molecular alignment has been disrupted.....always a weak spot
-
April 16th, 2019, 08:33 PM
#17
Has too much time on their hands
Originally Posted by
bansidthe
Take it back....that is a real problem since the molecular alignment has been disrupted.....always a weak spot
Hmm... didn't want to hear that! Well, if you think it's a problem, I should take that seriously... It was such a good deal, I figure I could try to correct it and live with it... I have 90 days to decide...
thanks