-
May 15th, 2017, 11:17 PM
#1
Launching/Retrieving: Power On/Off vs. Line
Just curious what most do when it comes to launching and retrieving their boat... Once the boat floats, I've always (1 year of ownership) taken the winch strap off and physically pulled the boat off with the mooring lines and tied to the dock (and vice versa for retrieving). My way has been easy and I've had no issues, but I boat owning friend tell me that I should be powering off and on as it is faster... My feet may get wet, but I can easily winch my boat back on too.
I'm looking forward to this new season and will be trying different spots (Parry Sound-ish areas)
(PS - I did a search before writing this).
Last edited by Part9; May 15th, 2017 at 11:21 PM.
-
May 15th, 2017 11:17 PM
# ADS
-
May 16th, 2017, 07:22 AM
#2
I have found that the main thing is too keep the boat secured by the winch strap on til it is down the ramp and in the water. I then leave the winch cable out so it is ready to hook on for recovery. Seldom do I get my feet wet, seldom do I have a helper and seldom is there a line up at the ramp. There are a few ramps I use that do have docks to walk on however...makes things easier.
On gentle ramps I remove the winch cable and replace it with my bow line so I can drive ahead and pull the boat to shore.
Last edited by patvetzal; May 16th, 2017 at 07:25 AM.
-
May 16th, 2017, 07:23 AM
#3
Depends on what kind of boat you have, sometimes with tinners its easier to do it the way you are. however with a 20' bass boat i need to power it on to have its fully secured.
-
May 25th, 2017, 09:44 PM
#4
I usually have a helper, who holds the anchor line tied to the bow and pulls the boat to shore or dock. To load on the trailer, I back in and extend the winch line and winch it on. I have had way too many frustrating days where I try to drive on and the wind or current has other ideas. I extend just enough line to clear the back of the trailer and then pull the line in until the boat starts riding the first roller. after that she has no choice and comes onto the trailer usually centered on the bunks.. Maybe 5% of the time I have to shift it up to 4-5" sideways to center it after I pull it out of the water. Pull the plug, safety chain the bow eye, strap her down and hit the road.
Learn all you can about nature. What we don't understand, we fear and what we fear, we destroy.
Teach a young person to hunt and fish, after all, someone taught you.
-
May 25th, 2017, 10:03 PM
#5
All the launches I use don't have a dock to tie to,so,I clip the bow mooring line to a ring on the trailer,reverse until the boat floats free,then,carefully pull the trailer out of the water until the boat is slightly aground at the ramp. Park the truck and trailer and I'm away. Retrieving is a tad trickier,but,essentially just the reverse except in heavy weather when I power on to the trailer after tying off to shore and backing the trailer into the water. Very rarely do I encounter other people waiting to launch or retrieve.
If a tree falls on your ex in the woods and nobody hears it,you should probably still get rid of your chainsaw. Just sayin'....
-
May 26th, 2017, 06:36 AM
#6
Please dont be one of the morons that power on and blow all the stone away with your prop wash. Its awesome when the water goes down and the risk of dropping your trailer onto the concrete pad is there.
Sent from my E6653 using Tapatalk
-
May 26th, 2017, 08:28 AM
#7
Most of the damage done to my boat and trailer was during launching and docking, I learned to leave the motor off when it was getting loaded/launched.
National Association for Search and Rescue
-
May 26th, 2017, 08:45 AM
#8
Good Question
I just bought a new boat that saw water for the first time last weekend.
I roped it off because of lack of help.
A helper showed up later which drove it on at the end of the weekend.
You see all the fishing pro's on the fishing shows driving them off and the helper parking the trailer.
I have bunks.
Would you unhook it and back in to drive it off or do you always leave it hooked to the trailer until ready to float?
I have a 18'7" lund Impact.
Would you seasoned pro's consider going fishing alone or always with a partner?
------------------------------------------
Be kinder than necessary, for everyone you meet is fighting some kind of battle
-
May 26th, 2017, 08:48 AM
#9

Originally Posted by
Marker
Most of the damage done to my boat and trailer was during launching and docking, I learned to leave the motor off when it was getting loaded/launched.
X2. Unless it's really blowing the rollers in,I like to leave the motor up,too. It's a lot easier on the skag and prop.
If a tree falls on your ex in the woods and nobody hears it,you should probably still get rid of your chainsaw. Just sayin'....
-
May 26th, 2017, 12:06 PM
#10
Think it depends on type of trailer, rollers or bunks. If rollers, leave attached to trailer, I watched a guy dump his 18ft glass 8ft short of the water last year. I have bunks so I unhook, before go to water, tie bow line on to the truck than back in not fast until the boat will come off easy. Untie the bow line and pull off and tie to dock. Coming in I put trailer in to the depth I want, untie from dock and pull onto trailer, hook up winch line and hand crank it on. Lots of people do drive it on and it probably good for them. If drive it on then you have to jump out of boat and I have to many problems with my body to do that.