-
September 3rd, 2014, 11:58 AM
#21
Take the warning labels off. Darwin will solve the problem.
-
September 3rd, 2014 11:58 AM
# ADS
-
September 3rd, 2014, 12:22 PM
#22
Looks like they did the trick. Good luck tomorrow.
---------------------------------------------------------------------------------
Canadian Waterfowl Supplies Pro Staff | Go Hunt Birds Field Staff
-
September 3rd, 2014, 03:55 PM
#23
Originally Posted by
TurkeyRookie
Looks like they did the trick. Good luck tomorrow.
The primer coat looked great the first time too..till it it peeled off the next morning..
I made need to go back over it later and do repairs and hit it with a sealer to protect it from scrapes more.
Take the warning labels off. Darwin will solve the problem.
-
September 4th, 2014, 07:49 PM
#24
Well it's scratched chipped rubbed, and still hanging on..:thumbs.
It must be doing me some good slide up on two geese....got one.
Take the warning labels off. Darwin will solve the problem.
-
September 4th, 2014, 08:29 PM
#25
---------------------------------------------------------------------------------
Canadian Waterfowl Supplies Pro Staff | Go Hunt Birds Field Staff
-
September 9th, 2014, 06:43 AM
#26
Has too much time on their hands
light sanding, at least you started with the wifes
-
September 14th, 2014, 07:27 AM
#27
Gotta quickly chime in before it gets ugly again. What you need is wax and grease remover. I use DuPont wax and grease remover for all my paint jobs. You can purchase this at carquest or certain UAP/napa stores. Here is the biggest advice I can give you.......go to an automotive paint store!!!! I would suggest any Carquest or Napa that has a dedicated Paint technician there. The Napa in newmarket is great. They will set you up with what you really need.
Uncle Stevie approved
-
November 27th, 2014, 09:10 PM
#28
Most pvcs that are moulded have a release agent inside. I saw a vid on you tube of a guy doing fourwheeler plastics and he was heating the plastic with a torch quickly until it looks wet and wiping off right away with rubbing alcohol. Apparently this process draws out the release agent.
-
November 27th, 2014, 09:48 PM
#29
Has too much time on their hands
One of the plants I work at makes plastic jugs.. They run the jug through a fire ring before they get labeled or the paint won't stick
Member of the OFAH, CCFR/CCDAF.
http://firearmrights.ca/
-
November 27th, 2014, 10:35 PM
#30
Originally Posted by
tenpoint guy
Most pvcs that are moulded have a release agent inside. I saw a vid on you tube of a guy doing fourwheeler plastics and he was heating the plastic with a torch quickly until it looks wet and wiping off right away with rubbing alcohol. Apparently this process draws out the release agent.
Acetone works real good too.
Take the warning labels off. Darwin will solve the problem.
Reply With Quote
