Reducing LOP on Benelly SuperNova SteadyGrip

[410001661]

Well after looking at several blogs showing me how to do this I finally decided to finally reduce my LOP on my Super Nova Steady Grip. First off I had to cut the stock down to the proper length (for me it was a little over a 1/4" (15mm to be exact - hey I'm Canadian).

Once that was done I had removed the remainder of the inside rib that was used to hold in the old recoil pad using a Dremel tool. Once that was done I took a piece of wood (I used a hard wood) and traced a rough guideline of the stock on the block and cut it down on the band saw. Once that was done the work started. I used an electric sander and shaped the block to fit into the stock - remembering you needed to know your angles in order to taper the block to match that of the inside of the stock. Go very slow at this point......sand a bit and measure, measure again and then sand. It took me about an hour to sand the block down but it fits perfectly.

Attachment 31799Attachment 31800Attachment 31801Attachment 31802


Once the block was fitted I prepared for the epoxy. I sanded the inside 1" of the stock so that it was rough then cleaned the area of all dust and debris - I wanted a good seal. I then mixed the epoxy and applied a coat to the inside of the stock and a thin coat to the wood block. I carefully inserted the filler careful not to push it into the stock too far. Once it was in place I ran a skim coat of epoxy on the top of the block to fill in any gaps between the block and the stock. I let it cure for 24hrs and here is how it turned out - perfect.

Attachment 31803

Now I need to drill out a hole to get access to the bolt that mounts the stock to the receiver. Again be careful as this needs to be on a slight angle and large enough to fit a socket through - I will use a drill press and a forstner bit for this job as not to chew up the block. Once that is done I can start shaping the recoil pad and mount it to the block - I will be using a pilot hole to avoid any cracking of the wood. I will post pics as I complete this project.

[ninepointer]

Now THAT is a post that many will find useful!