Your spud bar....

[73hunter]

I use an old rock drill bit that I found on a jobsite, but I’m finding it pretty heavy to haul out there, what does everybody else use ?

[Species8472]

Mine is similar to this. Solid steel and heavy as $%^& but works well.

https://www.lowes.ca/product/digging...E&gclsrc=aw.ds

[Tigboy 304]

Leaf spring out of a pickup works well for a blade. I welded it into a 1 1/2" tube.

[dean.f]

I've seen a million homemade bars, most are made with a rebar shaft and a pipe for the T handle. Usually a clay tooth from an auger or a piece of cutting edge from a loader bucket welded on the end. I made a light duty one with pipe for a handle and a flatbar chisel on the end but it doesn't penetrate like a heavy bar if you use it to check while walking.

[fishfood]

I have a solid steel bar heavy as sin with a pointed end thing pokes thru 2.5 inches no problem with one hit. I get cautious when it pokes thru on the first hit gotta stop and check around. . Just did a nice walk before dark 2.5 inches under the snow gotta be over 5 without the snow on spots lol. Going to be close to some broken up fresh stuff might do some trolling [emoji1787].

Going to try for a Whittie tomorrow [emoji106]



Sent from my CLT-L04 using Tapatalk

[oaknut]

Leaf spring out of a pickup works well for a blade. I welded it into a 1 1/2" tube.

Same idea here, only difference is a wooden handle. Cold steel on a cold day sucks.

Until I see over 16 inches of ice I don't bother with an auger, good exercise in the old chop chop.

Sent from my SM-G973W using Tapatalk

[dean.f]

Same idea here, only difference is a wooden handle. Cold steel on a cold day sucks.

Until I see over 16 inches of ice I don't bother with an auger, good exercise in the old chop chop.

Sent from my SM-G973W using Tapatalk

I like the idea of a wood handle.

[Bushmoose]

I've made several over the years for friends. 3/4" pipe, 4 ft. long with about a 6" T welded to top (rope spliced on of course) I'll use an old cold chisel for the head or a piece of leaf spring sharpened up. I use a chunk of heavy industrial rubber hose for a guard on the cutting head.

[oaknut]

I like the idea of a wood handle.

Replacement shovel handle with a hole drilled in it for a rope. The rope is a good thing unless you have a buddy like mine that sheepishly looks at you empty handed from out on the ice. "I didn't think I needed to use it" he says.....

Sent from my SM-G973W using Tapatalk

[73hunter]

Well I guess what I am using is pretty typical after all. You don’t know till you ask....