After hearing all the hype about this new turkey load I thought I would give it a try just to see how it performed in my set-up. Up until now I have tried several different turkey loads with varying results. Before I get into the results let me explain how I test each shell.
I first make sure my gun is zero'd in - I get up close & personal and use target loads to make sure I am punching out the bull of the target like a clean paper punch and then I back up to 20yds and throw a known performing turkey load at paper so make sure the pattern is evenly surrounding the center of the target - that verifies I am zero'd in on the target. My targets are standard 11x17 pieces of paper with a 10" circle around a bull (used only for centering the scope). I do this every year to make sure my scope has not been bumped or knocked out of alignment.
For my evaluation I shoot the same 3 shells at different distances (20, 30 & 40yds). What I am looking for is a consistent (and dense) pattern around the center of the target - you do not want holes or an inconsistent pattern. I only count the hits on the 40yd target because the 20 is usually a big jagged hole and the 30 is still too dense to count. The reason I count is because I want to make sure the pattern keeps its integrity out past 30yds and does not open or fall apart as the shot velocity diminishes - and it allows me to compare one shell to another. So my set up for these shell tests was a Benelli Super Nova Steady Grip with an Indian Creek Choke - like many beautiful ladies good ole Nelli has had some 'work' done to her - cones were lengthened, and I took some weight off the trigger and took some creep out of the trigger so she snaps nicely at just under 3lbs. I also use my Benelli AL391 26" bbl as a turkey gun every now and again and it uses the same choke as my Benelli Indian Creek 0.665
My present turkey load for my gun set-up is the infamous HEVI 13 (3" 2oz #6) - the reason why I say infamous is because the shells are $8/shell (USD) and are like hens teeth to fine up here in Canada, but there is a reason why they are $8 shell........these things are deadly!! I have seen lots of #4's and #5's and that illegal blend that BPS always markets this time of the year #5, #6, & #7.5, but the 2oz #6 seems to be rare, but for good reason. I am down to my last 7 shells and that was part of the reason why I am looking for options.
HEVI 13
I have tried a couple of different HEVI 13 shells and the 3" 2oz #6 patterned the best. I tied the 3" 1-3/4 oz #6 but the results were terrible! I was getting better patterns out of standard Winchester HV's but when I tried the 2oz load the results were amazing!! They have a very consistent pattern and since these are denser than lead they will be harder hitting then a standard copper plated lead shot. I have killed many turkeys with these shells and have taken some shots north of 50yds and they drop the birds in their tracks. Here are two targets I shot at 40yds with HEVI 13.......one had 162 hits and a very consistent pattern and one had 154 hits and you can see that I pulled the shot a bit........but is would still be one dead bird regardless.
Winchester Long Beard XR
As I mentioned earlier I have been hearing nothing but good things about the new(er) Winchester Long Beard so I decided to give it a whirl. I did no research on what shell to try so I went with my standard offering of a 3" #6 (1-3/4 oz). First thing I noticed was the way the hull was crimped - it looked like a solid piece of plastic with perforations where it would have been crimped. Probably waterproof but the overall quality of the shell looked very good. My 20yd shot was a ragged hole (which even a target load can do) but my 30yd shot showed lots of promise as the pattern was very dense and consistent around the center of the target. I went back to 40yds and threw a shell into Nelli and steadied for my shot and slowly squeezed the trigger and BOOOM. I racked the action sending the spent shell to my right and then I set the gun down and got up and walked towards the target. As I get closer the pattern comes into view and my exact words were WTF!! The pattern was amazing..........seriously it was really good! Anything in that 10" circle was simply dead. I set up another target and went back 40yds and loaded another shell and shot again - I wanted to make sure this was not a fluke. As I walked towards the target the second time I could see that identical peppering around that 10" circle. I was not overly impressed with Winchester loads before this but this time they nailed it - these XR's perform way better (at lease from a pattern point of view - I cannot talk about the downrange energy) than their Xtanded Range shell that I tried a couple of years back.
I tried the Winchester HV 3-1/2" #6 with decent results and the Winchester Xtended Range 3" #6 with very poor results. So I am glad to see they redeemed themselves with the XR!
Now.....what to do on the 25th........what shell to bring with me?? I think I will stick with my present set-up because I think there is something to be said about the higher downrange energy of the heavier than lead shot over standard copper plated lead. Now with only 7 shells left I feel comfortable that I now have a replacement that performs equally as well and costs a fraction of the cost.
Cheers,
John
Don't be that guy........April 25th will come fast
Reply With Quote
Originally Posted by 410001661
