Turkey fan mounts

[Markster]

Hey, is anyone doing tail fan mounts from their birds?
It looks pretty straight forward. Any tricks to know about?

[Articcat]

Hi Markster, just make sure you remove as much fat and flesh as possible without damaging the feathers and put a lot of borax to cure what's left. leave plenty of back feathers so you can trim as needed to the look you want, also pin the tail in the open position on a sheet of heavy cardboard or plywood and leave in a cool dry place to cure. Don't forget Google has a ton of info also.

[Jerryklimczuk]

Hey, is anyone doing tail fan mounts from their birds?
It looks pretty straight forward. Any tricks to know about?

Trim as much flesh off of the tail piece you cut off. Open the fan to 180 degrees, use the 3 nail method on a piece of wood to hold the fan open, borax the crap out of the flesh that is left over and let it dry out. It will hold its shape once the flesh has dried. I have done this method a bunch and it works well.

Sent from my SM-G986W using Tapatalk

[Squeakfish]

Hey, is anyone doing tail fan mounts from their birds?
It looks pretty straight forward. Any tricks to know about?

Make sure you get as much meat off the fan as possible.Pin it open on cardboard with lots of borax and let it sit 2-3 weeks.cut 2 half moons out of a 1x6 and a spacer when the bottom of the fan mount is dry and the fan stays open on its own you are ready to go

[Markster]

Thanks for the info guys.
I bought one of those 3 beard mounts and traced the design onto 1/8 inch hardboard for the next one.
Its ok quality, but not great if you know what i mean.
If anyone is interested , i have the tools to make a few extra.
Just let me know.
I have some cherry, white oak, red oak and pine around.
If i’m going to make 1 i might as well make 5.

[Jerryklimczuk]

Thanks for the info guys.
I bought one of those 3 beard mounts and traced the design onto 1/8 inch hardboard for the next one.
Its ok quality, but not great if you know what i mean.
If anyone is interested , i have the tools to make a few extra.
Just let me know.
I have some cherry, white oak, red oak and pine around.
If i’m going to make 1 i might as well make 5.

I'd be interested, how much are you asking? Cherry for me if possible and I would like 2. Let me know.

Sent from my SM-G986W using Tapatalk

[rick_iles]

If you want to do something different with the spurs, cut them off the leg bone, just above and below the spur. Clean off all the leg skin and clean bone marrow. Put borax on them. Next get about a 18 inches of leather shoe lace, make a loop. Feed each end of the loop through the spur, where the bone marrow was, one on each side of your loop. Feed them up a few inches, have the spurs point the same direction. Now cut off the brass of the shell you used. Push out the primer. Push both ends of the leather loop, through the primer hole about half way in. Now, take the beard, ensure it’s free of meat, skin etc., and has been Boraxed for a few hours. Fill the brass with hot glue and press the beard into the glue and brass shell end. It ends up like a necklace of sorts….

[Articcat]

Hey Rick, would you have a picture of the way you did the spurs and beard

[rick_iles]

Hey Rick, would you have a picture of the way you did the spurs and beard

I do, but haven’t figured out posting pics

[tom gobble]

Everyone summed it up already. I try different things all the time. The last thing I tried was cutting a natural piece of wood and I transferred the picture of the moment into the wood and mounted the tail fan and beard to it. Where are you located